<u>ASUS</u> <u>WL-500g</u> Premium <u>Router</u> –

Router asus wl-500g manual

ASUS WL-500g Premium Router – 262.14 Bogo MIPS (lpj=524288) [ 0.048000] pid_max: default: 32768 minimum: 301 [ 0.052000] Mount-cache hash table entries: 512 [ 0.060000] NET: Registered protocol family 16 [ 0.096000] bio: create slab at 0 [ 0.108000] Switching to clocksource MIPS [ 0.124000] ssb: PCIcore in host mode found [ 0.432000] PCI host bridge to bus 00 [ 0.436000] pci_bus 00: root bus resource [mem 0x40000000-0x7fffffff] [ 0.444000] pci_bus 00: root bus resource [io 0x0100-0x07ff] [ 0.448000] pci 00.0: [14e04] type 0 class 0x000600 [ 0.448000] PCI: Fixing up bridge 00.0 [ 0.452000] pci 00.0: setting latency timer to 64 [ 0.452000] PCI: Fixing up device 00.0 [ 0.456000] PCI: Fixing latency timer of device 00.0 to 168 [ 0.464000] pci 00.0: reg 10: [mem 0x00000000-0x00001fff] [ 0.464000] pci 00.0: reg 14: [mem 0x00000000-0x07ffffff pref] [ 0.464000] pci 00.0: [14e18] type 0 class 0x000280 [ 0.464000] pci 00.0: reg 10: [mem 0x00000000-0x00001fff] [ 0.464000] pci 00.0: [1138] type 0 class 0x000c03 [ 0.464000] pci 00.0: reg 20: [io 0xfce0-0xfcff] [ 0.464000] pci 00.0: supports D1 D2 [ 0.464000] pci 00.0: PME# supported from D0 D1 D2 D3hot [ 0.464000] pci 00.1: [1138] type 0 class 0x000c03 [ 0.464000] pci 00.1: reg 20: [io 0xfce0-0xfcff] [ 0.464000] pci 00.1: supports D1 D2 [ 0.464000] pci 00.1: PME# supported from D0 D1 D2 D3hot [ 0.464000] pci 00.2: [1104] type 0 class 0x000c03 [ 0.468000] pci 00.2: reg 10: [mem 0x00000000-0x000000ff] [ 0.468000] pci 00.2: supports D1 D2 [ 0.468000] pci 00.2: PME# supported from D0 D1 D2 D3hot [ 0.472000] pci 00.0: BAR 0: assned [mem 0x40000000-0x40001fff] [ 0.480000] pci 00.2: BAR 0: assned [mem 0x40002000-0x400020ff] [ 0.488000] pci 00.0: BAR 4: assned [io 0x0400-0x041f] [ 0.492000] pci 00.1: BAR 4: assned [io 0x0420-0x043f] [ 0.504000] PCI: Enabling device 00.0 (0000 - 0002) [ 0.512000] PCI: Fixing up device 00.0 [ 0.516000] b43-pci-bridge 00.0: setting latency timer to 64 [ 0.536000] ssb: Found chip with id 0x4318, rev 0x02 and package 0x02 [ 0.540000] ssb: Core 0 found: Chip Common (cc 0x800, rev 0x0D, vendor 0x4243) [ 0.540000] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x09, vendor 0x4243) [ 0.540000] ssb: Core 2 found: PCI (cc 0x804, rev 0x0C, vendor 0x4243) [ 0.540000] ssb: Core 3 found: PCMCIA (cc 0x80D, rev 0x07, vendor 0x4243) [ 0.560000] ssb: chipcommon status is 0x0 [ 0.564000] ssb: SPROM offset is 0x1000 [ 0.568000] ssb: SPROM revision 2 detected. Routers are often boring, but ASUS proves that doesn't have to be the case. The WL-500g is a very fast WiFi router that offers USB connectivity and even the ability to. This disc does not simply contain a manual though.

Setting opendns in the asus wl-500gp router - It is important that you put the firmware image into the ramdisk (/tmp) before you start flashing. [ 0.000000] ssb: set_irq: core 0x0806, irq 4 = 6 [ 0.000000] ssb: after irq reconfuration [ 0.000000] ssb: core 0x0800, irq : 2(S) 3* 4 5 6 D I [ 0.000000] ssb: core 0x0806, irq : 2(S) 3 4* 5 6 D I [ 0.000000] ssb: core 0x0806, irq : 2(S) 3 4 5* 6 D I [ 0.000000] ssb: core 0x0808, irq : 2(S)* 3 4 5 6 D I [ 0.000000] ssb: core 0x0804, irq : 2(S) 3 4 5 6* D I [ 0.000000] ssb: core 0x0816, irq : 2(S)* 3 4 5 6 D I [ 0.000000] ssb: core 0x0807, irq : 2(S)* 3 4 5 6 D I [ 0.000000] ssb: core 0x080b, irq : 2(S)* 3 4 5 6 D I [ 0.000000] ssb: core 0x080f, irq : 2(S) 3 4 5 6 D I* [ 0.000000] found parallel flash. Will extract v1 [ 0.000000] ssb: Sonics Silicon Backplane found at address 0x18000000 [ 0.000000] Serial init done. Setting opendns in the asus wl-500gp router. WL-500gP V2 - Multi-Functional Wireless Router - Manual - Duration. yash07raj 2,694.

Asus WL-500g Manual - SetupRouter [ 0.000000] Primary data cache 16k B, 2-way, VIPT, cache aliases, linesize 16 bytes [ 0.000000] Memory: 29100k/32768k available (2540k kernel code, 3668k reserved, 379k data, 168k init, 0k hhmem) [ 0.000000] NR_IRQS:128 [ 0.000000] console [tty S0] enabled [ 0.004000] Calibrating delay loop... WL-500gP Wireless Router User Manual. 5. The ASUS WL-500gP Wireless Router can meet various working scenarios with proper confuration. The default.

Asus WL-500g Premium V2 - DD-WRT upgrading to a new Open Wrt version you can upgrade using the d command line tool. Edit Introduction. Thought this would be a good place for ASUS WL-500G Premium v2 specific information similar to what has been added for other router.

to the Asus WL-500g Router - Don't be fooled: Port 1 on the v2 unit is number 3 when confuring VLANs. [ 0.000000] gpiochip_add: registered GPIOs 0 to 15 on device: bcm47xx [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 - 0x00002000 [ 0.000000] On node 0 totalpages: 8192 [ 0.000000] free_area_init_node: node 0, pgdat 802da6d0, node_mem_map 81000000 [ 0.000000] Normal zone: 64 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 8128 pages, LIFO batch:0 [ 0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Zone order, mobility ing on. Asus WL-500g Instructions. This page shows you how to to the Asus WL-500g router. Other Asus WL-500g Guides. Change your Asus WL-500g IP.

Asus WL-500g Reset - SetupRouter [ 0.588000] ssb: Sonics Silicon Backplane found on PCI device 00.0 [ 0.600000] NET: Registered protocol family 2 [ 0.604000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.612000] TCP established hash table entries: 1024 (order: 1, 8192 bytes) [ 0.620000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.624000] TCP: Hash tables confured (established 1024 bind 1024) [ 0.632000] TCP reno registered [ 0.636000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.640000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.648000] NET: Registered protocol family 1 [ 0.652000] PCI: CLS 0 bytes, default 16 [ 0.664000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.668000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. This guide will discuss how to reset the Asus WL-500g router. For a full set of instructions on securing your WiFi check out this How to Setup WiFi on the Asus.


Router asus wl-500g manual:

Rating: 93 / 100

Overall: 90 Rates

Add comment

Your e-mail will not be published. required fields are marked *